Screw Jack Torque and Self-Locking Calculator

    11
    0

    Calculate screwlı kriko torqueu and kendinden kilitleme calculator using engineering units and the defined formula.

    Engineering calculatorTool ID: AS-HSP-053-EN

    Screw Jack Torque and Self-Locking Calculator

    Calculate screw jack torque and self-locking calculator using engineering units and the defined formula.

    mm
    mm
    Enter the value required by the equation.
    mm
    Add this tool to your website

    Paste the code below into an HTML block on your website.

    Note: Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design. Tool version 2.7.1

    How to use this calculator

    1. Enter the measurements and operating values.
    2. Select the correct engineering unit for each value.
    3. Press Calculate to view the result and intermediate values.
    4. Review the equation steps and download a PDF report if needed.

    Equation used

    T = Wd/2 · (l+πμd)/(πd−μl) + Wμc rc

    How to evaluate the result

    Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design.

    Technical references

    Technical usage guide

    Input guide for Screw Jack Torque and Self-Locking Calculator

    Calculate screw jack torque and self-locking calculator using engineering units and the defined formula. The table below summarises the inputs and example starting values.

    ParameterExample valueUnits and description
    Kaldırılan yük25kN, N
    Screw ortalama çapı30mm
    Screw withrlemesi6mm — Enter the value required by the equation.
    Screw sürtünme katsayısı0.12Dimensionless or selection value
    Bwithzik sürtünme katsayısı0.08Dimensionless or selection value
    Mean bwithzik yarıçapı20mm

    Example calculation scenario

    For an initial check, enter the example values from the table, select the required units, and choose Calculate. Review the main result and equation, then replace the examples with measured or design data from your system.

    Common mistakes when using Screw Jack Torque and Self-Locking Calculator

    • Ignoring transmission efficiency, service factor, or transient operating conditions.
    • Mixing unit systems without checking the selected units.
    • Using example values instead of measured or design data from the actual system.
    • Accepting the result without checking safety factors, duty cycle, and manufacturer limits.

    Fundamental equation: T = Wd/2 · (l+πμd)/(πd−μl) + Wμc rc

    Frequently asked questions

    What is Screw Jack Torque and Self-Locking Calculator used for?

    Calculate screw jack torque and self-locking calculator using engineering units and the defined formula. Use it for preliminary engineering sizing and independent result checks.

    Which equation does this calculator use?

    The calculation is based on T = Wd/2 · (l+πμd)/(πd−μl) + Wμc rc. Inputs are converted according to the selected units.

    Can the result be used as a final design value?

    Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design. Confirm the result against the current standard, project specification, and manufacturer data.