Calculate kondens geri kazanım energy and maliyet tasarrufu using engineering units and the defined formula.
Condensate Recovery Energy and Cost Savings Calculator
Calculate condensate recovery energy and cost savings calculator using engineering units and the defined formula.
Result chart
Formula and calculation steps
Note: Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design. Tool version 2.7.1
How to use this calculator
- Enter the measurements and operating values.
- Select the correct engineering unit for each value.
- Press Calculate to view the result and intermediate values.
- Review the equation steps and download a PDF report if needed.
Equation used
Q=ṁcp(Tk−Tm); Yakıt=Q/(η·LHV)
How to evaluate the result
Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design.
Technical references
Input guide for Condensate Recovery Energy and Cost Savings Calculator
Calculate condensate recovery energy and cost savings calculator using engineering units and the defined formula. The table below summarises the inputs and example starting values.
| Parameter | Example value | Units and description |
|---|---|---|
| Back dönen kondens debisi | 3000 | kg/h |
| Kondens dönüş sıcaklığı | 90 | °C |
| Taze su sıcaklığı | 15 | °C |
| Annual çalışma | 6000 | saat/yıl |
| Kazan andrimi | 85 | % |
| Fuel alt ısıl değeri | 10 | kWh/birim |
| Fuel birim fiyatı | 15 | TL/birim |
| Fuel emisyon faktörü | 2.2 | kg CO₂/birim |
Example calculation scenario
For an initial check, enter the example values from the table, select the required units, and choose Calculate. Review the main result and equation, then replace the examples with measured or design data from your system.
Common mistakes when using Condensate Recovery Energy and Cost Savings Calculator
- Ignoring transmission efficiency, service factor, or transient operating conditions.
- Mixing unit systems without checking the selected units.
- Using example values instead of measured or design data from the actual system.
- Accepting the result without checking safety factors, duty cycle, and manufacturer limits.
Fundamental equation: Q=ṁcp(Tk−Tm); Yakıt=Q/(η·LHV)
Frequently asked questions
What is Condensate Recovery Energy and Cost Savings Calculator used for?
Calculate condensate recovery energy and cost savings calculator using engineering units and the defined formula. Use it for preliminary engineering sizing and independent result checks.
Which equation does this calculator use?
The calculation is based on Q=ṁcp(Tk−Tm); Yakıt=Q/(η·LHV). Inputs are converted according to the selected units.
Can the result be used as a final design value?
Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design. Confirm the result against the current standard, project specification, and manufacturer data.
