Calculate kondenstop kapasitesi and orifis Ön boyutlandırma using engineering units and the defined formula.
Steam Trap Capacity and Orifice Preliminary Sizing Calculator
Calculate steam trap capacity and orifice preliminary sizing calculator using engineering units and the defined formula.
Result chart
Formula and calculation steps
Note: Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design. Tool version 2.7.1
How to use this calculator
- Enter the measurements and operating values.
- Select the correct engineering unit for each value.
- Press Calculate to view the result and intermediate values.
- Review the equation steps and download a PDF report if needed.
Equation used
ṁ=CdA√(2ρΔp)
How to evaluate the result
Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design.
Technical references
Input guide for Steam Trap Capacity and Orifice Preliminary Sizing Calculator
Calculate steam trap capacity and orifice preliminary sizing calculator using engineering units and the defined formula. The table below summarises the inputs and example starting values.
| Parameter | Example value | Units and description |
|---|---|---|
| Normal kondens yükü | 1000 | kg/h |
| Safety katsayısı | 2 | Dimensionless or selection value |
| Input mutlak basıncı | 8 | bar(a) |
| Output mutlak basıncı | 1.2 | bar(a) |
| Kondens sıcaklığı | 120 | °C |
| Deşarj katsayısı Cd | 0.65 | Dimensionless or selection value |
Example calculation scenario
For an initial check, enter the example values from the table, select the required units, and choose Calculate. Review the main result and equation, then replace the examples with measured or design data from your system.
Common mistakes when using Steam Trap Capacity and Orifice Preliminary Sizing Calculator
- Ignoring transmission efficiency, service factor, or transient operating conditions.
- Mixing unit systems without checking the selected units.
- Using example values instead of measured or design data from the actual system.
- Accepting the result without checking safety factors, duty cycle, and manufacturer limits.
Fundamental equation: ṁ=CdA√(2ρΔp)
Frequently asked questions
What is Steam Trap Capacity and Orifice Preliminary Sizing Calculator used for?
Calculate steam trap capacity and orifice preliminary sizing calculator using engineering units and the defined formula. Use it for preliminary engineering sizing and independent result checks.
Which equation does this calculator use?
The calculation is based on ṁ=CdA√(2ρΔp). Inputs are converted according to the selected units.
Can the result be used as a final design value?
Results are for preliminary engineering evaluation. Verify assumptions, material data, safety factors, applicable standards, and manufacturer limits before final design. Confirm the result against the current standard, project specification, and manufacturer data.
